E2706 is carefully engineered for best performance and reliability. The sensor stem is made of a special light metal alloy for corrosion resistance and stiffness. The vertical slot in the stem reduces its clogging by residues in the fuel, facilitates cleaning and maintenance and improves the reaction time compared to closed tube geometry. The electronics box is completely sealed, providing protection from mechanical and corrosive impact.

The stem can be easily cut directly at the installation place up to 20% of the initial length to fit into the tank. Two standard lengths that suit the majority of fuel tanks are available: L800 mm which may be cut to 100 mm and L1600 mm which may be cut to 100 mm. The maximum stem length is limited to L2400 mm.

Evikon E2706 Fuel level sensor with CAN and 0-10 V Transmitter Specifications

Level sensitivity: > 2 units per mm, typically 15 units per mm

Resolution: < 0.1% of the range, typically 0.07 mm

Ambient temperature effect: <0.03%, typically ±0.01% of the range per °C, adjustable temperature compensation

Non-linearity: < 0,3% of the range

Digital integrating filters: Adjustable time constant and integrating factor, output change rate 15...240 mm/min

Digital interface: CAN 2.0B as per ISO 11898, 250 kbps baud rate, SAE J1939 compatible protocol

Analog interface: 0-10 V, programmable

Internal calibration: Digital calibration, internal calibration table up to 32 points, custom output units

Supply voltage: 10 to 72 VDC, transient overvoltage, reverse polarity, short circuit protection

Operating conditions: –40 to +85 °C, 0 to 100 %RH, IP67 protection

Fuel types: Petro-diesel, bio-diesel fuels with flash point higher than +60 °C