• Duracell ultra batteries are specially formulated to meet the increasing power demands of a new generation of high power devices
• 3.0 Volt – lithium

ZOLL AED PLUS LITHIUM BATTERIES (PACK OF 10)

ZOLL AED Plus defibrillator replacement batteries. Pack of 10 New Duracell Lithium batteries for replacement in ZOLL AED Plus. (1 pack is included with purchase of unit) Anticipated Life- 5 years in normal standby mode. Safety Nigeria features some of the lowest priced ZOLL AED Plus batteries online. 8000-0807-01, 10 batteries per pack. Need to replace the battery on your ZOLL AED Plus Defibrillator. You can buy your battery/batteries for your ZOLL AED Plus Automated External Defibrillator at the best prices online. 8000-0807-01

Installing Batteries in your ZOLL AED Plus. 

The ZOLL AED Plus takes consumer 10 lithium batteries (type 123 lithium batteries). We strongly recommend using only Duracell Ultra Type 123 Batteries to assure long life. Never use Panasonic or Rayovac per ZOLL Medical. Once new batteries have been installed the date should be recorded. Batteries installed in the ZOLL AED Plus typically have a 5 year life from the date of installation. A good rule of thumb is: if you have CPR-D pads(which also have a 5 year shelf life) you should make it routine to change the batteries at the same time as the 5 year pads. Watch the short video below to see how to install your new ZOLL AED Plus batteries. The dates stamped on the batteries is NOT an expiration date but it is a "install by" date. Get new batteries for your ZOLL AED Plus Automated External Defibrillator. 

Replace your battery in your ZOLL AED Plus Automated External Defibrillator. 8000-0807-01

***Important note on installing batteries in your ZOLL AED Plus Defibrillator. 

After you have installed all the new batteries in the ZOLL AED, the AED will say "if new batteries press button". MAKE SURE YOU PRESS THE BUTTON LOCATED IN THE BATTERY COMPARTMENT ONCE PROMPTED. IF YOU DO NOT DO THIS THE RED "X" COULD CONTINUE TO DISPLAY OR DISPLAY PREMATURELY. 

Maintenance/Technical Information

To remove the battery cover, insert a small tool (e.g., flat blade screw driver) into the two slots on the rear of the unit to depress the latches, then insert the tool into the groove on the bottom to lift the cover (see Figure 7).

2. Remove all batteries at once and dispose of batteries properly. Place new batteries into the battery bank, observing battery polarity markings and making sure that all batteries are securely seated and properly oriented. After placing the first 5 to 9 batteries in the battery well, the INSTALL BATTERIES audio prompt reminds you to install the remaining batteries in the battery compartment.

Figure 2

3. After installing new batteries, press the Battery Reset Button inside the battery compartment when prompted (see Figure 2). Pressing the button resets the battery usage indicator to full charge.